Subscribe to Our Youtube Channel
Related Manuals for Finnleo Hallmark V3 Series
Summary of Contents for Finnleo Hallmark V3 Series
-
Page 1: Table Of Contents
Hallmark V3 Series Owner’s Manual HM 46 and HM 57 with SL2 Control and CB 16-1 and Bluetooth Sound System HM V3 57 Room HM V3 46 Room Read Before Installation Precautions Before Use Room Assembly Electrical / Heater Assembly... -
Page 2: Read Before Installation
READ BEFORE INSTALLATION Read all instructions carefully before installation including instructions packaged separately with the sauna heater. Please leave all instructions and warranty with the owner. WARNING: When using electrical sauna heaters and associated sauna products, basic precautions must be followed, including the following: 1. -
Page 3: Room Assembly
ROOM ASSEMBLY The Hallmark Series is for Interior Installation Only. The sauna rooms come in different sizes. These instructions are only for the 4x6 and 5x7 Hallmark Series rooms. • Each panel is heavy. Be careful to avoid injury when installing, especially the top panel. •... - Page 4 ROOM ASSEMBLY (CONT.) 1. Place the floor panel in the desired location on a level surface Note: The floor panel must be level before installing wall and ceiling panels. If the surface is not level, you may need to shim the bottom panel to get level. The base is numbered to correspond with the panels for correct locations.
- Page 5 6. Place and latch front right wall to right side wall. 7. Place the ceiling panel on the wall panels. Note: Make sure the top panel’s front is facing the front, that the trim of the top panel fits completely around the walls and that the connection wires fron the control panel wall protrude through the hole of the ceiling panel.
-
Page 6: Electrical / Heater Assembly
ELECTRICAL / HEATER ASSEMBLY 9. Place CB Box on the floor for easy access. Remove the cover to access the electrical connections. 10. Connect all the quick connections according to the picture and installation manual into the CB Box. Note: All the low voltage connections have unique connectors. - Page 7 15. Determine power requirements and wire size needed based on the room model. WIRE SIZE Sauna Room Sauna Heater Phase Amps Power Supply to CB Box CB Box to Tradional Heater HM 46 Designer 4.5 18.8 2 #10AWG + GR 2 #10AWG + GR HM 57 Designer 6.0...
- Page 8 21. Assemble and install the wood heater guard around the sauna heater using the 1 1/8” screws provided. The heater guard location is marked on both walls with a label. Place the bottom of the heater guard to cover the label on the walls and secure into location.
-
Page 9: Bench / Interior Assembly
BENCH / INTERIOR ASSEMBLY Note: Install benches after electrical is work is completed and the control is working to test lights. Note: Bench supports are already installed in the proper location for the upper and lower benches, so no assembly of bench supports is required. - Page 10 31. Place back rest on top bench and connect the lighting from the right edge of the back to the back rest. Note: Test lights before mounting the back rest. 32. Install the backrests above the upper benches according to the predrilled holes, using the 1 1/8”...
-
Page 11: Sl2 Control Operations
SL2 (SaunaLogic 2) Control Operation Operating Instructions for Heater Default settings for temperature are preset to 194°F, the bath time is set to 60 minutes and 0-minute delay to start to heat. These settings are adjustable (as described below) from 119°F to 194°F. Length of sauna can be set from 0 to 60 minutes. -
Page 12: Bluetooth Sound System Operation
AUDIO OPERATION Audio Power On • Press icon to toggle On or Off the Bluetooth System. Note: The control does not have to be active for Sound System to operate. Pairing • Refer to your mobile device to pair to the unit. •...
Need help?
Do you have a question about the Hallmark V3 Series and is the answer not in the manual?
Questions and answers