Haier HSU-18RK03/R2 - annexe 1 Operation Manual

Split type room air conditioner
Hide thumbs Also See for HSU-18RK03/R2 - annexe 1:

Advertisement

SPLIT TYPE ROOM AIR CONDITIONER

OPERATION MANUAL

HSU-09RK03/R2(SDB)
HSU-12RK03/R2(SDB)
HSU-18RK03/R2(SDB)
HSU-09RS03/R2(SDB)
HSU-12RS03/R2(SDB)
Please read this operation manual before using the air conditioner.
Keep this operation manual for future reference.
0010532977
Contents
PARTS AND FUNCTIONS
OPERATION
CAUTIONS
TROUBLE SHOOTING
2
3
11
12

Advertisement

Table of Contents
loading

Summary of Contents for Haier HSU-18RK03/R2 - annexe 1

  • Page 1: Operation Manual

    SPLIT TYPE ROOM AIR CONDITIONER OPERATION MANUAL HSU-09RK03/R2(SDB) Contents HSU-12RK03/R2(SDB) HSU-18RK03/R2(SDB) PARTS AND FUNCTIONS HSU-09RS03/R2(SDB) OPERATION HSU-12RS03/R2(SDB) CAUTIONS TROUBLE SHOOTING Please read this operation manual before using the air conditioner. Keep this operation manual for future reference. 0010532977...
  • Page 2: Parts And Functions

    Don’t adjust it manually) Outer side of the controller 4.HEAT button Used to set HEAT operation. Please be subject to the actual produce (Cooling only unit do not SMART purchased, the above picture is just from SET TEMP. ROOM TEMP.
  • Page 3: Clock Set

    If the remote controller can’t run normally during operation, please remove the batteries and reload several minutes later. Hint: Remove the batteries in case unit won’t be in usage for a Remove the battery cover; long period.If there are any display after taking-out,just need...
  • Page 4: Smart Operation

    ” is displayed on the display board, unit will run in DRY mode. Under the cooling, heating and dehumidifying mode, press the smart key to enter the smart function. Under the smart running mode, when the air conditioning is running, it will automatically select 1.In DRY mode, when room temperature becomes lower...
  • Page 5: Swing Operation

    Unit will run at selected fan speed. When humidity is high,condensate water might occur at air outlet if all vertical louvers are adjusted to left or right. It is advisable not to keep horizontal flap at downward position for a long time in COOLor DRY mode , otherwise, condensate water might occur.
  • Page 6: Health Airflow Operation

    (It’s available under any mode) 4.In cooling and dry, using the air conditioner for a long time When the fan in the indoor unit does not work, under the high air humidity, a phenomenon falling drips of water occurs at the outlet grille .
  • Page 7: Timer Operation

    POWER/SOFT Operation Set Clock correctly before starting Timer operation.You can let unit start or stop automatically a following times:Before you wake up in the morning,or get back from outside or after POWER Operation you fall asleep at night. Select your desired operation...
  • Page 8 TIMER function, the sleeping function will be cancelled; the machine will be in the state of timing-on,if the two SLEEP SLEEP operation stops...
  • Page 9: Eco Operation

    When several people are located at different positions,or one person is moving in different areas, no matter whether the wind is blowing or not, the wind will automatically swing and blow to multi areas, the wind direction adjustment will be delayed, it cannot be deflected suddenly while detecting.
  • Page 10 Operation FRESH Operation Emergency operation and test operation Exhaust the vitiated air from the room, and inhale fresh air. Emergency Operation: (This function is unavailable on some models.) Use this operation only when the remote controller is defective or lost.
  • Page 11 Cautions WARNING Please call Sales/Service Shop for the Installation. Do not attempt to install the air conditioner by yourself because improper works may cause electric shock, fire, water leakage. WARNING Check proper installation When abnormality such as burnt-small found, Use an exclusive...
  • Page 12: Trouble Shooting

    : the dismantling of the air conditioning system, -Electomagnetic CompatibilitY 89/336/EEC treatment of the refrigerant, of oil and of other part must be done by a -Electomagnetic CompatibilitY 2004/108/EC qualified installer in accordance with relevant local and national legislation.

Table of Contents