Senquip QUAD Quick Start Manual

1. What is in the Box?
QUAD
3. Insert SIM Card
5. Enter Setup Mode
Press the setup
button to enter
setup mode and
activate the QUAD
webserver. The
green light will
flash.
7. Configure the QUAD
Configure Wi-Fi or
4G LTE connectivity
using the Network
tab. Save settings. If
using 4G LTE, set the
correct APN for your
SIM.
Close the lid to exit
setup mode.
9. Mounting the QUAD
QUAD Quick Start
Guide
Antenna
Allen key
Gland inserts
If using 4G LTE, insert a
SIM card carefully,
noting the orientation.
After completing step
4, wait 5 minutes. If
your SIM has Auto APN
enabled, it will
connect and you can
skip steps 5-7.
The QUAD includes
DIN-rail mount and
wall-mount options
integrated into the
enclosure. To panel
mount, screw directly
into the QUAD mount
points with the
screws provided
2. Open the QUAD
4. Apply Power
6. Connect to the Webserver
Use a phone or tablet to connect
to the QUAD Wi-Fi using the
SSID and Wi-Fi password located
under the lid.
Using a web-browser, go to
192.168.4.1.
"admin" and the QUAD setup
password to access the QUAD
webserver.
8. Access your Data
Create an
account on the
Senquip Portal to
manage devices,
view data, write
scripts, and
update
firmware.
10. LED Status Guide
STATUS NETWORK
Off Off
Flash (1Hz) Off
On Flash (1Hz)
On On
Fast Flash Fast Flash
Off Fast Flash
Slow Flash Off
Using the 3mm Allen
key provided, loosen
the 4 cover screws
ensuring that all 4
screws have ejected
before opening.
Apply power to
pin 1 and ground
to pin 2 of the
header. The green
light will go on
and orange light
will flash.
Enter username
Meaning
Device is sleeping
Setup Mode
No internet connection
Internet connection
Factory Reset
Firmware Update
Pre-charge mode