Table of Contents
Advertisement
DI-308 ISDN Remote Router
Flash 0 – disconnect the first phone call established.
Flash 1 – disconnect the second phone call established.
Flash 2 – switch between the two phone calls.
Flash 3 – speak to both parties simultaneously (if conference calling is enabled by
your phone company).
POTS Lines – [Plain Old Telephone Service]. Enables or disables phone calls on
the Phone 1 and Phone 2 jacks on the rear of the router.
Global Reception – When this is enabled, the Phone 1 and Phone 2 jacks will
receive all phone calls directed to them by the telephone company's switch. When
disabled, the router will check incoming calls to the Phone 1 and 2 jacks against
the telephone numbers specified in the A/B Adapter 1 and 2 fields above.
Block Outgoing CLID – When this is enabled, your ISDN data phone number
and voice phone numbers will never be sent out when trying to establish a
connection. Thus, even if sites being called have Caller ID, they still won't be
able to know your phone number.
Inbound Authentication – This defines the authorization protocol that will be
used when accepting a dial-in connection. The choices are Password
Authentication Protocol [PAP], Challenge Handshake Authentication Protocol
[CHAP] or None. PAP and CHAP do not provide a screen for users to manually
enter their Username and Password – instead, this data must be entered into the
dialing software before placing the call. Make sure the device dialing in is using
the same protocol as defined here. The None setting may be used when you do not
wish dial-in users or networks to identify themselves or be subject to security.
Call Bumping – This setting only takes effect when both B channels are
connected and using multi-link PPP. If this is the case and call bumping is
enabled, when you receive an outgoing voice call, the second B channel will be
dropped (with all traffic being moved to the first B channel) and the voice call
will be received. If disabled, both B channels will continue their data
transmissions uninterrupted and the voice call will be ignored.
State – Enables or disables the ISDN port.
Network Configuration
There is one main item on the DI-308 Network Configuration menu:
21
Advertisement
Table of Contents
