Adding Users To The Radius Database - D-Link DI-308 User Manual

RADIUS State – Use to Enable or Disable RADIUS.
Type – Refers to the type of external password protocol. Currently, only
RADIUS is supported.
Server IP Address – This is the IP Address of your Unix- or NT-based RADIUS
server.
Port – The port number for the RADIUS server. The standard port number
specified by RFC 1700 is 1812 (shown above).
Key – This is a shared secret used to identify the DI-308 as a valid RADIUS
client.
The Key password should be stored in the client file in the RADIUS server's
/etc/raddb directory. Lines of the form:
# Client Name
#-----------------------------
192.168.0.1
should be added to the client file. The Client Name field in the file gives the IP
address of the DI-308, and the Key field should be the same as the Key field in the
RADIUS Configuration submenu.
After a RADIUS server has been configured, the DI-308 will use it to authenticate
all users instead of checking its internal Dial-In User Profile.

Adding Users to the RADIUS Database

The DI-308 only uses the RADIUS database for user authentication. Except for the
User Name,Password and Framed_IP_Address fields, most standard RADIUS
attribute fields are ignored by the DI-308.
To add a user to the RADIUS database, edit the users file in the RADIUS server's
/etc/raddb directory, and add a line similar to the following:
joeuser
Each user should have a user name/password record in the Users database. It is also
possible to configure an IP address for each user by adding a line in the Users
database similar to the following:
Ip user
192.168.0.117
Key
dlink_customer
Password = "joepassword"
Password = "iusespecificip", Framed_IP_Address =
107
DI-308 ISDN Remote Router