Sends On Faders - Yamaha CL3 User Manual

Yamaha Commercial Audio
grey background when the Phase setting is normal and will change to
an orange background when Phase is reversed.
4.9

SENDS ON FADERS

Press the [SENDS ON FADERS] button in the left column of the Mixer screen
to access sends to Mix Busses. In "SENDS ON FADERS" mode, each fader
controls the send level from its channel to the currently selected Mix. The
fader level indicators in the "Navigation/Meter Bridge" will show the positions
of all the Mix Send Levels if the appropriate Preference is On in the Setup
screen (refer to 8.6).
The large [MIX ON FADERS] button displays the currently selected Mix Bus
number and its name. The color of this button matches those used in the
series console.
[CUE] and [ON] buttons appear below the [SENDS ON FADERS] button,
allowing the currently active Mix Bus to be Cued and turned On/Off.
There are two ways to select a target Mix Bus:
a) Use a swipe gesture on the [MIX ON FADERS] button to
increment/decrement through the Mix and Matrix Busses.
b) Press the [MIX ON FADERS] button to access a popup screen which
allows direct selection of any Mix or Matrix Bus.
CL StageMix V3.0 User Guide
Page 15