Cool And Dry Operation - Haier HSU-09LF03 - annexe 1 Operation Manual

Operation

COOL and DRY operation

Recommendations:
(1) Unit start
Press ON/OFF button, unit starts.
Previous operation status appears on display. (Not Timer setting)
Power indicator on indoor unit lights up.
(2) Select operation mode
Press MODE button. For each press, operation
mode changes as follows:
AUTO COOL
Unit will run in operation mode displayed on LCD.
Stop display at your desired mode.
(3) Select temp. setting
Press TEMP button.
Every time the button is pressed, temp. setting increases 1
Every time the button is pressed, temp. setting decreases 1
Unit will start running to reach the temp. setting on LCD.
(4) Fan speed selection
Press FAN button. For each press, fan speed changes
as follows:
AUTO LO
Unit runs at the speed displayed on LCD.
In DRY mode, when room temperature becomes
lower than temp.setting+2
at LOW speed regardless of FAN setting.
Hints
On cooling only unit, heating mode is not available.
Remote controller can memorize each operation status. When starting it next time,
just press ON/OFF button and unit will run in previous status.
Use COOL in summer.
Use DRY in spring, autumn and in damp climate.
DRY FAN
MED
o
C,unit will run intermittently
o
C
o
C
HI
COOL operation starts when room
temp. is higher than temp. setting.
Temp. setting+2
Temp. setting
7
ON/OFF TEMP
1
3
6
MODE
2
FAN
TIMER
4
SWING CLOCK
5
SLEEP
LOCK
RESET
Ultra-low air flow
o C
On reaching temp. setting, unit
will run in mild DRY mode.
3
SET