Rear Panel - Yamaha R-S700BL Owner's Manual

Rear panel

1 TRIGGER OUT jack (R-S700 only)
When this unit is turned on or when a certain input source
is selected, this unit can send a 12 V/100 mA direct
electric current via the TRIGGER OUT jack that can be
used to control an external component. The current is sent
according to the "Trigger out" setting in the Option menu
(see page 40).
Note
Do not connect a component that requires more than 100 mA of
electric current, otherwise the component may not perform
consistently or properly due to insufficient power.
2 REMOTE 2 IN jack (R-S700 only)
Used to receive remote control signals (see page 45).
3 REMOTE 1 IN/OUT jacks
Used to send and receive remote control signals (see page
45).
4 GND terminal
Used to connect a turntable (see page 12).
5 ZONE 2 OUT jacks
Used to connect a Zone 2 component (see page 45).
6 Antenna terminals
Used to connect FM and AM antennas (see page 14).
7 TAPE jacks
Used to connect a tape deck (see page 12).
8 DOCK jack
Used to connect an optional Yamaha Universal Dock for
iPod (such as the YDS-12), Wireless System for iPod
(YID-W10), or Bluetooth Wireless Audio Receiver
(YBA-10) (see page 35).
9 PHONO jacks
Used to connect a turntable (see page 12).
(R-S700)
0 CD jacks
Used to connect a CD player (see page 12).
A LINE 1-3 jacks
Used to connect audio components (see page 12).
B iPod VIDEO output jack (R-S700 only)
Used to send iPhone/iPod video content to a video
monitor, such as a TV (see page 35).
Note
Video content output is possible only when an iPhone/iPod is
connected this unit using a Universal Dock for iPod (such as the
YDS-12).
C SIRIUS jack
Used to connect SiriusConnect tuner (sold separately) (see
page 27).
D COUPLER jacks (R-S700 only)
Used to connect an external unit (see page 15).
E SUBWOOFER OUT jack
Used to connect a subwoofer with built-in amplifier (see
page 12).
F POWER MANAGEMENT switch
Used to enable or disable the automatic power down
function. When this function is enabled, this unit's Main
zone and Zone 2 automatically enters standby mode if this
unit is not operated for a certain amount of time (3 settings
are available; see page 43).
G SPEAKERS terminals
Used to connect speakers (see page 12).
H IMPEDANCE SELECTOR switch
Used to select the impedance setting (see page 13).
I AC IN (R-S700 only)
Used to plug in the supplied power cable (see page 15).
CONTROLS AND FUNCTIONS
CONTROLS AND FUNCTIONS
7
En