Foreword General This manual introduces the functions and operations of the ESS. Models ESS1504C, ESS1508C Safety Instructions The following categorized signal words with defined meaning might appear in the manual. Signal Words Meaning Indicates a high potential hazard which, if not avoided, will DANGER result in death or serious injury.
Page 3
regions. For detailed information, see the paper manual, CD-ROM, QR code or our official website. If there is inconsistency between paper manual and the electronic version, the electronic version shall prevail. All the designs and software are subject to change without prior written notice. The product ...
Important Safeguards and Warnings Electrical Safety All installation and operation should conform to your local electrical safety codes. The power source shall conform to the requirement of the Safety Extra Low Voltage (SELV) standard, and supply power with rated voltage which conforms to Limited power Source requirement according to IEC60950-1.
Overview Introduction The ESS can work as extended storage for network video storage devices. You can connect the ESS to the target device, and then there are more disk bays available. Features Support 1T, 2T, 3T, 4T, and 6T SATA3.0 disks, you can select 4-bay or 8-bay model. ...
Operation Turning on and off Turning on You must turn on the ESS first, and then the target device. Connect the power cable and the eSATA cable properly, and then press the ESS power button. The RUN light on the rear panel flashes, which means the ESS is successfully turned on. Turning off You must turn off the target device first, and then the ESS.
Cybersecurity Recommendations Cybersecurity is more than just a buzzword: it’s something that pertains to every device that is connected to the internet. IP video surveillance is not immune to cyber risks, but taking basic steps toward protecting and strengthening networks and networked appliances will make them less susceptible to attacks.
Page 12
Change Default HTTP and Other Service Ports We suggest you to change default HTTP and other service ports into any set of numbers between 1024~65535, reducing the risk of outsiders being able to guess which ports you are using. Enable HTTPS We suggest you to enable HTTPS, so that you visit Web service through a secure communication channel.
Page 13
The network should be partitioned and isolated according to the actual network needs. If there are no communication requirements between two sub networks, it is suggested to use VLAN, network GAP and other technologies to partition the network, so as to achieve the network isolation effect.
Need help?
Do you have a question about the ESS150 C Series and is the answer not in the manual?
Questions and answers