Local Cable Network Service; Prepare Your Workspace For The Installation - D-Link DCM-202 Manual

Local Cable Network Service

Before installing the modem:
1 Read this entire User's Manual from front to back in sequence.
2 Find the Serial Number, RF and Ethernet address located on a sticker on
the cable modem and write them here:
Serial Number S/N: ____________________
RF and ETH MAC: ____________________
3 Contact your local cable service operator for Internet/cable network
access. Your local cable operator will check for cable access availability in
your area, install a cable line (if necessary), provide you with an access
account, set up configuration and verify other technical details.
4 Ask your local cable service provider about adding additional IP addresses
to your account. See " Which Installation to Use?" for more information.
Prepare Your Workspace for the Cable Modem
Installation
Before installing the cable modem, you should prepare your workspace. You
can install the cable modem vertically, or attach the included four rubber feet
and install the cable modem horizontally.
To prepare your workspace:
1 Position the cable modem so that it is located near the computer and the
wall cable outlet. There should be plenty of room to guide the cables away
from the cable modem without crimping them.
2 Prepare the cable modem:
For vertical installation: Place the cable modem securely in the
included stand.
For horizontal installation: Use the four included feet to install the
cable modem.
5