Perky-Pet Country Style Squirrel-Be-Gone II Manual

To Install Hanger:
1. Lift lid to remove.
2. Insert the hanger end with the 3 bends (Fig. 1) into the left side
panel. There are two holes, insert into the upper one. (Fig. 2)
3. Bring the other end of the hanger around the back of the feeder
as shown.
4. Place other hanger end into the single hole found on the right
side panel. (Fig. 3) Important Note: To insert properly, you will
have the hanger in a down position, pointing to the back of the
feeder as shown.
5. While pushing the hanger into the hole, lift the hanger into the
upright position. You will notice the end of the hanger on the
left side panel, springing out from the lower hole as indicated.
(Fig. 4) This will lock the hanger in an upright position.
To Install Weather Vane:
1. Insert bottom shaft of weather vane through top of roof peak.
2. Attach locking key to shaft and secure with screw as shown.
(Fig. 5)
See our full line of Perky-Pet
855-757-5973 | Woodstream Corporation | 69 N. Locust Street Lititz, PA 17543, USA
Country Style Squirrel-Be-Gone II
Model #338
®
birdfeeders and accessories at www.perkypet.com
1.
2.
3.
WEATHER
VANE PARTS
screw
locking key
shaft
4.
5.
ABOVE ROOF
UNDER
ROOF
Pg. 1