This section explains how to record from the tuner, CD player, or
\-——_:",- _— _.,
Insertion of 4-second blank spaces enables activation of the
Music Sensor function. (Applicable when the source is TUNER
REC/REC MUTE button during recording or
while in recording pause mode.
on the display flashes for 4 seconds and the tape runs
without recording. After 4 seconds, the deck enters the
recording pause mode.
Press the 11 button to resume recording.
To stop recording, press the
To pause recording, press the 11 button. (Applicable when the
source is TUNER, VI DEO/AUX.)
To resume recording, press
To start recording with the remote control
First press the
REC/REC MUTE button, and then press
button within 2 seconds.
INSERTING BLANK SPACES
Set the tape to the point where recording will start.
Use Type I (normal) and Type
(high/CrOz) tapes for recording.
Insert the tape to be recorded on into deck 2.
Insert the tape with the side to be recorded on first facing
out from the unit and the exposed side down.
Press the REV MODE button to select the reverse
To record on one side only, turn on =.
To record on both sides, turn on => or (Z).
Press the DOLBY NR button to turn Dolby NR on
To record with DOLBY NR, turn on DO NR.
To record without DOLBY NR, turn off 00 NR.
Press one of the function buttons and prepare
the source to be recorded.
To record from a CD, press the CD button and load the
To record from a radio broadcast, press the TUNER button
and tune in to a station.
To record from the connected
source, press the VIDEO/
AUX button and play.
When the selected function is CD, playback and recording
To insert a blank space of less than 4 seconds, press the
REC/REC MUTE button again while =
To insert blank spaces of more than 4 seconds, after the
deck enters recording pause mode, press the O RECIREC MUTE
button again. Each time the button is pressed, a 4-second blank
space is added.
To erase a recording
Make sure the microphone is not connected to this unit.
Insert the tape to be erased into deck 2 and press the TAPE/
DECK 1/2 button to display "TAPE 2".
Set the tape to the point where the erasure is to be started.
Set the reverse mode by pressing the REV MODE button.
REC/REC MUTE button to start the erasure.