D-Link DCS-6620G User Manual page 40

DCS-6620G User's Manual
Configuration > Advanced > Network (continued)
WLAN Configuration Settings (continued)
Wireless mode:
D-Link Systems, Inc.
(Service Set Identifier) is a name that identifies your wireless
SSID:
network. Access Points and wireless clients attempting to
connect to a specific WLAN (Wireless Local Area Network)
must use the same SSID. The default setting is default.
Click on the pull-down menu; select from thefollowing options:
Infrastructure – connecting the WLAN using an Access Point
such as the DWL-1000AP+. (The default setting.)
Ad-Hoc – wireless mode used when connecting directly to a
computer equipped with a wireless adapter in a peer-to-peer
environment (use this setting if you do not have an Access
Point).
Channel: The default wireless channel setting is channel 6. Select the
channel that is the same as the other wireless devices on your
network.
Select the transmission rate on the network. Auto is the default
TX rate:
setting.
Select Long or Short Preamble. The Preamble defines the
Preamble:
length of the CRC block (Cyclic Redundancy Check is a
common technique for detecting data transmission errors) for
communication between the Access Point and the roaming
wireless Network adapters. Long Preamble is the default
setting. Note: High network traffic areas should use the shorter
preamble type.
Security: Choose one of the following modes:
None – No encryption is selected.
WEP – The user can select 64-bit or 128-bit encrytpion in HEX
or ASCII mode.
WPA-PSK – Selecting this mode will require an input of the
preshared key between the camera and the wireless device it
is connected to.
Auth Mode:
Choose one of the following authorization modes:
Auto – Will automatically adjust to the Authentication mode of
the wireless client.
Shared Authentication – Allows communication only with other
devices with identical WEP settings.
Open Authentication – Communicates the key across the
network.
Key length:
Select the key length of 64-bits (10 characters in HEX or 5 in
ASCII), 128-bits (26 characters in HEX or 13 in ASCII).
Key format:
Select either HEX or ASCII.
Using the DCS-6620G with an Internet Browser
40