Troubleshooting - AEG Protect D 1000 LI-ION User Manual

78

7. TROUBLESHOOTING

Typical alarms and faults:
To check the UPS status and Event log:
Press any button on the front panel display to activate the menu
•
options.
Press the button to select Event log.
•
Scroll through the listed events and faults.
•
The following table describes typical conditions:
Conditions Possible cause
Battery mode A
occurred, and the UPS
is in Battery mode.
LED is On. 1
beep every 4
seconds.
Battery low The UPS is in Battery
mode and the battery is
running low.
LED is On.
1 beep every
second.
No battery The
disconnected.
LED is On.
Beep
continuous.
Battery fault The battery test is failed
due
disconnected batteries,
or the battery minimum
utility failure has
batteries are
to bad or
Action
The UPS is powering the
equipment with battery
power. Prepare
equipment for shutdown.
This warning
approximate, and
actual time to shutdown
may vary significantly.
Depending on the UPS
load and the number of
EBPs (Extended Battery
packs), an alarm may
occur before the battery
capacity reaches
percent.
Make sure all batteries
are properly connected, if
the problem persist,
contact your service
representative.
Make sure all batteries
are properly connected, if
the problem persist,
contact your service
your
is
the
20