SEVERIN LITTLE 1200 HT 9600 Important Safety Instructions

Dear Customer
Before using the appliance, the user should
read the following instructions carefully.
Connection to the mains supply
The hair dryer should only be connected to
an earthed socket installed in accordance
with the regulations.
Make sure that the supply voltage
corresponds with the voltage marked on the
rating label of the hair dryer.
Models with dual-voltage selector:
Models equipped with a dual voltage switch
can be set to different supply voltages by
using a coin or a similar object. Make sure
that the set voltage corresponds with the
supply voltage.
This product complies with all binding CE
labelling directives.
Important safety instructions
●
Caution: do not use the
appliance near bath tubs,
washbasins or any other
receptacle containing water.
Protect the appliance from moisture and
splashing water and do not operate it
with wet hands.
●
In the vicinity of any water source, there
is a risk even when the appliance is
switched off. Therefore, always remove
the plug from the wall socket after use,
especially if the appliance is being used in
a bathroom.
Additional protection is available by
fitting an earth-leakage circuit-breaker
with a rated tripping current not
exceeding 30mA into your bathroom
installation. Please consult a qualified
electrician.
●
Electric heating appliances operate at
very high temperatures. Do not touch
any part of the appliance except the grip.
Otherwise there is a real risk of burning.
Hair dryer
●
Do not use the appliance on synthetic
hair-pieces or wigs, as the heat emitted
might cause damage to the synthetic
fibres.
●
Make sure the air intake and outlet
openings are not blocked (e.g. by fingers
or hair), and that no fluff or fibre
particles are allowed to accumulate in the
air intake.
A blockage in the air-flow system may
cause the integral thermal safety cut-out
to switch off the appliance. Should this
occur, immediately disconnect the
appliance from the mains power and
allow sufficient time for it to cool down
before the blockage is removed and the
appliance is switched on again.
●
Every time the appliance is used, the
main body including the power cord as
well as any attachment fitted should be
checked thoroughly for any defects.
Should the appliance, for instance, have
been dropped onto a hard surface, it
must no longer be used: even invisible
damage may have adverse effects on the
operational safety of the appliance.
●
To prevent damage to the power cord,
- do not bend or kink the cable,
especially where it leaves the housing,
- do not pull on the cord,
- do not coil the power cord around the
appliance.
●
Do not leave the appliance unattended
while in use.
●
Always switch off and remove the plug
from the wall socket after use, as well as
- in cases of malfunction, and
- during cleaning.
●
When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
●
Do not place the appliance on any
surfaces sensitive to heat during or
immediately after use.
●
This appliance is not intended for use by
any person (including children) with
reduced physical, sensory or mental
capabilities, or lacking experience and
3