Table of Contents
Advertisement
09
l
! You can't use the Virtual Wide mode when the headphones are connected to this receiver or when any of the stereo, Front
Stage Surround Advance, Sound Retriever Air or Stream Direct modes is selected.
! You can only use the Virtual Wide mode if the surround speakers are on and the FW setting is set to NO. It can also not be
used when playing signals containing actual front wide channel information.
m You can't use the Virtual Depth mode when the headphones are connected to this receiver or Stream Direct modes is selected.
n When Speaker System is set to 7.1ch Front Bi-Amp, 5.1ch Bi-Amp + ZONE 2, 5.1ch F+Surr Bi-Amp or 5.1ch F+C Bi-Amp,
the AMP setting is locked at ON and cannot be changed.
Setting the Video options
There are a number of additional picture settings you can make using the VIDEO PARAMETER menu. The
defaults, if not stated, are listed in bold.
Important
! Note that if an option cannot be selected on the VIDEO PARAMETER menu, it is unavailable due to the current
source, setting and status of the receiver.
! All of the setting items can be set for each input function.
! Setting items other than V.CONV can only be selected when V.CONV is set to ON.
1
Press
to the receiver operation mode, then press VIDEO PARAMETER.
2
Use i/j to select the setting you want to adjust.
Depending on the current status/mode of the receiver, certain options may not be able to be selected. Check the
table below for notes on this.
3
Use k/l to set as necessary.
See the table below for the options available for each setting.
4
Press RETURN to confirm and exit the menu.
Video parameter menu
Setting
What it does
V.CONV
Converts video signals for output from the HDMI OUT connector for
(Digital Video Converter)
all video types (see
<a>
Specifies the output resolution of the video signal (when video input
RES
signals are output at the HDMI OUT connector, select this according
(Resolution)
to the resolution of your monitor and the images you wish to watch).
<b>
("480p" indicates the 480p/576p resolution setting.)
This setting optimizes the operation of the progressive scanning cir-
PCINEMA
(PureCinema)
cuit for playing film materials. Normally set it to AUTO. If the picture
<c, e>
seems unnatural, switch this to ON or OFF.
P.MOTION
Adjusts the motion and still picture quality when video output is set
(Progressive Motion)
to progressive.
<c, e>
This improves elements that reduce picture quality mainly noticeable
in network contents, such as mosquito noise and block noise.
STREAM
When AUTO is selected, this unit's Stream Smoother function
(Stream Smoother)
automatically turns on when network contents are played on the
<e>
player supporting Stream Smoother Link and connected to this unit
by HDMI (assuming that integrated operation with the Control with
HDMI function is set). (Stream Smoother Link)
76
Using other functions
Option(s)
ON
page
29).
OFF
AUTO
PURE
480p
720p
1080i
1080p
1080/24p
AUTO
ON
OFF
c –4 to +4 d
Default: 0
OFF
ON
AUTO
Advertisement
Table of Contents
