Auto Timer - Everstar MPA-08CR Instruction Manual

Setting the AUTO-ON TIMER(cont'd)
5) All of the settings are now registered.
THE UNIT"OFF" USING THE I/O SWITCH.
6) To set the AUTO-ON
turned to the "off" position (non-operational).
7) Press the TIMER-ON
AUTO-ON time sequence. Fig. 32. The display
window will indicate
will flash for 5 seconds. Press the
to select the desired
Fig.32a.
Key pad will decrease the
Setting in 10 minute increments.
Keypad will increase the
Setting in 10 minute increments.
When the desired time is established,(the time
will flash in the display window) press the
CLOCK key pad to register the
ON program. The word
remain "on" (TIMER ON)
is set. The time of day clock setting will
immediately revert back in the display window.
IMPORTANT: The desired AUTO-ON time must
be registered within a 5 second period (after
pressing the TIMER-ON key pad) otherwise the
selected time will mot register and the system
will automatically revert back to the regular
"time of day" clock setting. If this occurs, you
must repeat step 7 again.
The unit will start automatically when the specified
AUTO-ON time is achieved on the time of day clock
(the "TIMER ON" prompt will disappear from the
display window). To cancel or override the
TIMED program,simply turn on the unit before the
AUTO-ON time is scheduled to operate (the
ON" prompt will disappear from the display window)
You can varify the AUTO-ON
(prior to the program starting )by pressing the
TIMER-ON key pad. The time you selected will
appear(flash)temporarily(replacing the time of day)
for approximately 5 seconds.
TURN
timer, the unit must be
key pad to initiate the
TIMER-ON and the word
or
AUTO-ON start time.
AUTO-TIMED
AUTO-TIMED

AUTO TIMER-

ON will stop flashing and
indicating the program
AUTO-
time selection anytime
ON
ON
TIMER
key
ON
TIMER
"TIMER
14
MODE
I/O
12:00
FAN ON
TIMER
SWING OFF
MODE
I/O
12:00
FAN ON
TIMER
SWING OFF
CLOCK
Fig. 32
CLOCK
Fig. 32a