Installation - Zanussi FJ1011/A Use And Care Instructions Manual

Installation
Unpacking
Having removed the outer carton,
reinforcing angles, and polythene
wrapping, you must take out the internal
packing which protected the appliance's
«works» during transit.
Using the plastic spanner provided,
remove the three large bolts from the
back of the machine to free the washing
drum (Figure 1).
Each bolt leaves behind a plastic spacer
inside the machine, this should be
worked loose by inserting a screwdriver
into the bolt hole, allowing the spacer to
drop to the bottom of the machine.
Lay the machine carefully on its back to
reveal two pieces of polythene band in the
base (Figure 2). First pull band A then
band B to withdraw the remaining
internal packing, taking care not to catch
and damage any of the appliance's
internal components in this process.
Finally, lift the appliance of the
polystyrene base packing and remove the
plastic spacers you worked loose earlier.
These spacers, together with the three
large bolts and other internal packing
should be kept in a safe place so they
can be used if the machine has to be
transported again.