12. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
12.1 Error Codes
The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the table). If the problem persists, contact the
Authorised Service Centre.
WARNING!
Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an error
code and the Start/Pause button may flash continuously:
Error code
Appliance motor overloaded.
E50
Too much laundry or entrapped in the drum.
Internal fail. No communication between
electronic elements of the appliance.
E90 or E91
The mains supply is unstable.
EH0
If the display shows other error codes, deactivate and activate the appliance. If the problem
continues, contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible solutions.
12.2 Troubleshooting
Problem
You cannot activate the appliance.
The drum does not rotate.
The programme does not start.
22
ENGLISH
Possible cause
Possible solution
Make sure that the mains plug is connected to the
mains socket.
Check fuse in fuse box (domestic installation).
Release the rear drum locks manually (see chapter
fore First Use ).
Press Start/Pause.
Make sure that the appliance door is closed.
Remedy
The programme was not completed. Re‐
move the laundry from the drum, set the
programme and restart the cycle.
The programme was not finished properly
or the appliance stoped too early. Switch
the appliance off and on again.
If the error code appears again, contact the
Authorised Service Centre.
When the appliance is showing EH0, please
wait until main supply is stable than press
start. If the appliance paused the cycle with‐
out any indication then press the cycle start.
If the warning will occur again check the
power cord / socket integrity or main supply.
Be‐