Toshiba RAD-DIA17HK User Manual page 35

To remove:
· Press down the tab on the lter and pull it outward, then take it out.
· Clean the lter with warm, soapy water. Rinse and let the lter dry before replacing it. Do not clean the lter in
a dishwasher.
To attach:
· Insert the air lter and HEPA lter into the unit from underside to upside.
· HEPA lter is recommended to be replaced once every 6 months.
1
Remove the rear grille.
2
Install HEPA filter with
handle strap. Mount
outwards for replacement.
CAUTION
DO NOT operate the dehumidi er without a lter because dirt and lint will clog it and reduce
performance.
NOTE
The cabinet and front may be dusted with an oil-free cloth or washed with a cloth dampened in a solution of
warm water and mildliquid dishwashing detergent. Rinse thoroughly and wipe dry. Never use harsh cleansers,
wax or polish on the cabinet front. Be sure to wring excess water from the cloth before wiping around the
controls.
Excess water in or around the controls may cause damage to the unit.
Drain clean
Clean the bucket drain
· Insert a straw brush with a diameter smaller than 10mm into the drain, scrape up and down to prevent dirt
from accumulating inside the hole.
· The outside of the drain can be wiped with a cotton cloth.
NOTE: Be sure to
remove the plastic
sealing film before
using HEPA filter.
Clean the permanent drain
Page 15