PCB Piezotronics IMI SENSORS EX640B00 Installation And Operating Manual page 41

IMI5EN5OR5
A PCB PIEZOTRONICS DIV.
I
EXAMINATION CERTIFICATE
2
Component Intended for use in Potentially Explosive Atmospheres meeting ATEX
Directive 2014/34/EU
3
Examination Certificate Number: CTDOII X to be used in conjunction with the Type
Examination Certificate LClE 05 ATEX 6154 X, Issue: 01
4 Apparatus: Models EX64xAOy, EXM64xAOy, EX64xBOy, and EXM64xBOy Series
EXRV64xA0y, EXRVM64xAOy, EXRV64xBOy, and EXRVM64xBOy Series
EXT064xA3y, EXTOM64xA3y, EXT064xB3y, and EXTOM64xB3y Series
EX64xA1 y, EXM64xA1 y, EXT064xAl y, EXRV64xA1 y, EXTOM64xAl y, and EXRVM64xAl y Series
EX64xB1y, EXM64xB1y, EXT064xB1y, EXRV64xB1y, EXTOM64xB1y, and EXRVM64xB1y Series
EX64xA6y, EXM64xA6y, EXT064xA6y, EXRV64xA6y, EXTOM64xA6y, and EXRVM64xA6y Series
EX64136y, EXM64xB6y, EXT064136y, EXRV64xB6y, EXTOM64136y, and EXRVM64xB6y Series
EX64137y, EXT064137y, and EXRV64xB7y Series
The "x" and "y" represent a single digit from 0-9 representing model number and connector type
5 Manufacturer: IMI Sensors, a Division of PCB Piezotronics
6 Address: 3425 Walden Avenue, Depew, New York, 14043
7
This apparatus and any acceptable variation are specified in the schedule in this certificate and
all pertinent documents referenced.
8
lMl Sensors certifies that this component has been found to comply with the Essential Health
and Safety Requirements relating to the design and construction of components intended to form part
of Category 3 equipment intended for use in potentially explosive atmospheres given in Annex II to
European Union Directive 2014/34/EU of February 2014. This certificate is based on LCIE
confidential report(s) n° 60058689/559760 and 60040901/5 40946/1, for the above models certified to
Equipment Group II Category I Gas Group.
9 Compliance with the Essential Health and Safety Requirements has been assured by
compliance with:
EN 60079-0:2012+AI1:2013
EN 60079-11:2012
10 The apparatus may be connected to other ATEX certified equipment, as long as it meets the
parameters of the system.
11
This Examination Certificate relates only to the design and construction of this specified
equipment in accordance to Directive 2014/34/EU
Page 1 of 3