Outdoor Unit - Haier HSU-09HJ03 Installation Manual

Connection
Connection of the rapid connector
1.Take off the cover of
the plastic protection
6.Close the "discharge lever" to
discharge the refrigerant gas
Separate the two ends and repeat
Repete step from 6 to 3.
The way how to connect the cable
of indoor and outdoor units
You can see the Terminal block was fixed on
the outdoor units after remove the stop valve cover,
The connect cable was covered by the connect pipe
of indoor unit,the end of which is Terminal block b.
When you make the connection of the cable of indoor
and outdoor units,please remove the cable clip C first
and then insert and lock the Terminal block a and Terminal
block b to each other.Please inpact the connect cable by Cable
clip C and then fix it by screw. That's all.

Outdoor unit

2.Take off the prootections
from the male and female ends
5.Connect the male and female sides.
Ensure a complete connection.
3.Open the "discharge lever"
4.Pull back the
"Retractable sleeve"
connect the
cable