Power Failure Resume Function; Operation Mode - Haier HSU-05LEA03 Operation Manual

Operation
Comfortable SLEEP
Operation
Before going to bed, you can simply press the
SLEEP button and unit will operate in SLEEP
mode and bring you a sound sleep.
Use of SLEEP function
After the unit starts, set the operation status,
then press SLEEP button before which the
clock must be adjusted and time being set.
ON/OFF TEMP
MODE SET
FAN
TIMER
SWING CLOCK
SLEEP HEALTH
LOCK RESET

Operation Mode

1. In COOL,DRY mode
1 hours after SLEEP mode starts, temp. will
become 1 O C higher than temp. setting. After
another 1 hours, temp. rises by 1
The unit will run for further 6 hours then stops.
Temp. is higher than temp. setting so that room
temperature won't be too Iow for your sleep.
SLEEP operation starts
Approx.6hrs
Rises 1
1 hr
O
Rises 1
1 hr
Temp.setting
In COOL, DRY mode
2. In HEAT mode
1 hours after SLEEP mode starts, temp will
become 2 C lower than temp.setting. After
O
another 1 hours, temp decrease by 2 C
further. After more another 3 hours, temp.
O
rises by 1 C further. The unit will run for
O C further.
SLEEP operation stops
O
C
C
Unit stop
O
further 3 hours then stops. Temp. is lower
than temp. setting so that room temperature
won't be too high for your sleep.
Temp.setting
1 hr
Decreases 2
1 hr
Decreases 2
3 hrs
SLEEP
operation starts
In HEAT mode
3. In AUTO mode
The unit operates in corresponding sleep
mode adapted to the automatically selected
operation mode.
4. In FAN mode
It has no SLEEP function.
When TIMER function is set, the sleeping
5.
function can't be set up .After the sleeping
function is set up,if user resets TIMER function,
the sleeping function will be cancelled; the
machine will be in the state of timing-on.
6.Note to the power failure resume:
press the sleep button ten times in five seconds
and enter this function after hearing four sounds.
And press the sleep button ten times within five
seconds and leave this function after hearing
two sounds.

Power Failure Resume Function

If the unit is started for the first time, the
compressor will not start running unless 3
minutes have elapsed. When the power
resumes after power failure, the unit will run
automatically, and 3 minutes later the
compressor starts running.
15
Unit stop
O C
O C
3 hrs
Rises 1 O C
SLEEP
operation stops