Whenin Trouble - JVC BR-S822U Service Training

Safely Removing a Cassette
1.7 WHENIN TROUBLE
1.7.1. To take cassette out of set manually
If a loaded tape cannot be ejected because of electrical
failure, etc., take It out in the following manner.
1.
2.
Turn off the power and remove the top cover.
Open the operation panel and set SW1-4 gw
on [31] M. CTL & R. SERVO board to
ON.
4
2
|=] ON
. Turn on the power and the mode becomes to emergency
roll mode.
Depress the tact switch SW2 on the M. CTL board while
rotating the loading motor clockwise. The mechanism
starts unloading while taking in the slack of the tape.
_ After the mechanism returns to the loading end position,
turn the gear of the cassette housing clockwise and take
out the cassette tape. If itis hard to turn the gear, remove
the cassette panel and do the same.
BR-S822 Course
Mechanism Control and Servos page 12