Preroll Time - JVC BR-S822U Service Training

Menu No. On-Screen Settings Explanation
Description Counter On-Screen
SYSTEM | 313 | PB*PB/EF Selects output signal in the mode specified with menu item
#314,
. 00 PB/EE PB/EE: Outputs EE signal.
[01] [PB] PB: Outputs playback signal.
314 | PB/EE MODE
Selects the mode in which EE signal is output.
[00] [STOP/FF/REW] | STOP/FF/REW: EE signal is output in Stop, FF and REW
modes.
01 STOP STOP: EE signal is not output in FF and REW modes.
315 | LOCAL [00] [STOP,EJECT] Selects functions that can be locally operated when front
FUNCTION 01 STP,EJ,PLY,FF, | panel REMOTE switch is set to 9PIN or REM-2.
RW,STL
02 ALL ENABLE
03 ALL DISABLE
316 | SPIN CMD Selects 9-pin remote control commands that are acceptable
FUNCTION when front panel REMOTE switch is set to LOCAL.
[00] [ALL DISABLE] | ALL DISABLE: Accepts no command from 9-pin remote
01 STOP,EJECT control.
STOP,EJECT: Accepts STOP and EJECT commands only.
(Note: With some remote controls, no command is
accepted.)
317 | SPIN DEVICE Selects device type ID returned from VCR to 9-pin remote
TYPE ID control in response to its request.
[00] [JVC SVHS-1] JVC SVHS-1: Use this setting with BR-S622DXU/BR-
01 JVC SVHS-2 S822DXU.
JVC SVHS-2: Use this setting if SA-F911U is included in
02 OTHER TYPE-1 the system.
03 OTHER TYPE-2 | OTHER TYPE-1/OTHER TYPE-2: Consult a JVC dealer.
318 | TCDATAW/O TC Selects VCR's response to 9-pin remote control when
BOARD remote contro! requests time code data when TC board is
not installed.
[00] [TC MISSING] TC MISSING: VCR returns code meaning TC MISSING.
01 CTL DATA CTL DATA: VCR returns substitute CTL data.
319 | TAPE MAX [00} [X70] Selects maximum tape speed.
SPEED 01 X32 (FF and REW speeds also correspond to this setting. In the
02 X16 70x mode, the EE signal is output. In the 32x and 16x
search modes, the playback signal is output. The CTL
signal is not output in the 16x search mode.)
320 | PREROLL TIME 00 OSEC Selects preroll time in one-second steps from 0 to 15
: : seconds.
[05] [5 SEC]
15 | 15SEC
321 | TIME REF. FOR Selects time count reference for preroll in TC operation.
PREROLL 00 CTL CTL: Refers to CTL counts. Preroll is possible even when
time codes are missing.
(01) [TC] TC : Refers to time codes.
322 | INPOINT AUTO Activates or defeats automatic IN point entry function.
ENTRY 00 NOT ENTERED NOT ENTERED: IN point is not entered automatically by
pressing PREROLL button. .
[01] [ENTERED] ENTERED: IN point is entered automatically by pressing
| PREROLL button if no IN point has been previously
entered.
323 | MODE AFTER (00) [STOP] STOP: Enters Stop mode after preroll is completed.
PREROLL 01 STILL STILL: Enters Still mode after preroll is completed.
BR-S822 Course Introduction page 15