Recording Mute - Pioneer CT-W620R Operating Instructions Manual

h DECK | and DECK II, CT-W620R/CT-W502R/CT-W420R/CT-W402R: DECK H only)
sing DECK II
rf).
» BLE button of
nly)
AUTO BLE display
steadily (see page
h to the == posi-
h to either the =>
ou wish to rec-
| prepare it for
see "ADJUST-
the pause (#1)
> button. lf the <
r only one side is
88) button again,
"3 dB" indicator lights steadily most of the time. No harm will be
done if the "O dB" indicator lights momentarily at peaks. When
recording without Dolby NR, set the REC LEVEL control so that the
"—3 dB" indicator lights, and the "O dB" indicator lights occasion-
ally at peaks.
NOTES:
® . The optimal recording level may differ somewhat depending on
the audio source and type of tape used. In order to obtain the
best possible results, set the recording level after actual testing.
Listen to your recordings, and adjust the level as necessary.
® The level meter may react differently during recording and
playback of the same tape. This is due to differences in tape
sensitivity, and creates no problem.
RECORDING USING MICROPHONE
(CT-W602R only)
1. Connect the plug of the microphone to the MIC jack.
2. Follow the procedure for RECORDING given above.
®@ To adjust mic recording level (step 7), use the mic level con-
trol (LEVEL) instead of the REC LEVEL control.
® Set the REC LEVEL control to its minimum position when
recording with a microphone only.
<Mixing recording>
Turn the REC LEVEL control up gradually after playing back
music source during microphone recording.
Use both the REC LEVEL control and the MIC LEVEL control to
adjust miximg level balance between microphone sound level
and line source sound level.
NOTES:
@ The MIC LEVEL control is only effective when a microphone is
connected to the MIC jack.
® Be sure to disconnect the microphone plug from the MIC jack
when not using the microphone for recording.
@ Use a commercially available microphone when recording.
RECORDING MUTE
Use this function to create the 4-second blanks required for proper
operation of the music search function.
® Press the recording mute (© ) button during recording and the
deck will create a blank space by recording a section which
contains no signal for approximately four seconds. The deck
will then enter recording standby mode.
| a ee ee ae 8 ed NN PREY Nae ENR AT CLEC AMEE, DS eae OEE HOM URLS SRT OO |