ASROCK 775TWINS-HDTV User Manual page 14

Note: If you use only one IDE device on this motherboard, please set the IDE
device as "Master". Please refer to the instruction of your IDE device vendor
for the details. Besides, to optimize compatibility and performance, please
connect your hard disk drive to the primary IDE connector (IDE1, blue) and
CD-ROM to the secondary IDE connector (IDE2, black).
Serial ATA Connectors
(SATA1: see p.2 No. 16)
(SATA2: see p.2 No. 15)
(SATA3: see p.2 No. 14)
(SATA4: see p.2 No. 13)
Serial ATA (SATA)
Data Cable
Serial ATA (SATA)
Power Cable
connect to the SATA
(Optional)
HDD power connector
VGA_2x8 Cable
AV/S_2x3 Cable
VGA Header
(VGA1: see p.2 No. 32)
1 4 1 4 1 4
1 4 1 4
ASRock 775Twins-HDTV Motherboard
These four Serial ATA (SATA)
connectors support SATA data
cables for internal storage
devices. The current SATA
interface allows up to 1.5 Gb/s
data transfer rate.
Either end of the SATA data cable
can be connected to the SATA
hard disk or the SATA connector
on the motherboard.
Please connect the black end of
SATA power cable to the power
connector on each drive. Then
connect the white end of SATA
connect to the
power cable to the power
power supply
connector of the power supply.
Please connect either end of
VGA_2X8 cable to J1 jumper of
VGA_HDTV panel and the other
end to VGA1 header of this
motherboard.
Please connect either end of
AV/S_2x3 cable to J2 jumper of
VGA_HDTV panel and the other
end to TV-OUT header of this
motherboard.
Please connect either end of
VGA_2X8 cable to VGA header.