Download  Print this page

Aiwa CDC-Z117 Operating Instructions Manual Page 5

Stereo car cd receiver.
Hide thumbs

Advertisement

Presetting stations manually
(Manual Memory)
1
Press FNC repeatedly to select the desired band
(FM1, FM2, FM3, AM1 or AM2).
2
Press TUNEi or TUNEk to tune in to a desired
station (see "Tuning in to a station," page 3).
3
Press the desired preset station button until the unit
beeps.
Note
A newly preset station replaces the station on the same
band that was previously stored on that preset station
button.
Tuning in to a preset station
1
Press FNC repeatedly to select the desired band
(FM1, FM2, FM3, AM1 or AM2).
2
Press the preset station button on which the desired
station is stored.
Active tuning reception control (ATRC)
The unit automatically suppresses FM noise caused by
vehicle movement, and maintains sound quality.
Using the timer
(My Information)
You can schedule the radio to activate for daily radio
programs. The unit automatically turns on and off in
Radio mode at the scheduled times.
MY INFO indicator
Smart Job
Setting the timer
1
Turn off the unit.
2
Press and hold INFO until "PO" flashes in the
display.
3
Press SEL.
4
Set the time you wish the unit to turn on.
• Press TUNEi and turn the Smart Jog to set the hour.
• Press TUNEk and turn the Smart Jog to set the
minute.
5
Press SEL.
6
Press FNC to select the band.
7
Press TUNEi, TUNEk or the desired preset station
button to select the station.
8
Press SEL.
9
Set the time you wish the unit to turn off following the
same procedure used in step 4.
10
Press and hold INFO until the unit turns off, and
setting is completed.
When the unit is on, "MY INFO" appears in the
display indicating that the unit is standby for a timer.
During the timer-activated tuning, "MY INFO"
continues to flash.
To cancel the timer standby, press INFO so that
"MY INFO" disappears.
Note
• To discontinue the timer setting, press and hold PWR/
MUTE until the unit turns off.
• To check the setting, turn off the unit, then press INFO.
The unit displays the scheduled turn-on and turn-off
times with the appropriate radio frequency.
• The unit automatically starts tuning at the scheduled
time regardless of the current source mode. When the
scheduled program is over, the unit automatically
returns to the former source mode.
• Timer setting remains enabled even if you turn off the
unit, and then turn it on.
• However, if you press FNC to change the source mode
during timer-activated tuning, the scheduled program
is canceled.
4
4
ENGLISH
ENGLISH

Advertisement

Table of Contents

   Also See for Aiwa CDC-Z117

   Related Manuals for Aiwa CDC-Z117

Comments to this Manuals

Symbols: 0
Latest comments: