Power Cord Connection - Gree GMV-VQ280WM/C-X Owner's Manual

GMV Heat Recovery DC Inverter VRF

3.8.3 Power Cord Connection

3.8.3.1 Power Cord Installation Procedures
Step 1: Pass the external power cord through the wire-passing rubber gasket of the chassis seal
board, and connect the power cord's "L1, L2, L3, N,
marked with "L1, L2, L3, N,
Step 2: Tighten the cable with a cable tie.
Step 3: Please refer to the engineering wiring mark on the unit for the power cord connection.
WARNING! When the strong wire and the communication line pass through the wire hole, they
must be equipped with wire rubber ring.
3.8.3.2 External Wiring Diagram
Each unit should be equipped with a circuit breaker for short circuit and abnormal overload
protection. The circuit breaker is normally closed.
" respectively and the grounding screw beside the power wiring board.
Fig.3.8.2
Fig.3.8.3
47
" and ground wire to the power wiring board