Radio Operation; Restoring Factory Settings; Muting Button Beep Sounds; Aligning Source Levels - Aiwa CDC-X527M Operating Instructions Manual

Adjusting sound

You can select the following modes for adjusting sound
depending on the music you listen to: BASS (low
frequencies), TRE (high frequencies), BAL (left/right),
FAD (front/ rear) , H-BASS (high bass) and
BBE(enhances the clarity of high-frequency sound).
1
Press SEL repeatedly to select the mode to be
adjusted.
Pressing SEL cycles through the modes. The
selected mode's indicator flashes.
2
Turn AUDIO CONTROL to increase/decrease the
level or to select on/off or on1/on2/off
selected mode.
Note
Adjust the level or select on/off within 5 seconds, or the
selected mode will return to previous state.
Aligning the source levels
(Source Level Adjuster)
Volume may vary each time you change the source
mode. In this case, you can align each source mode's
volume to almost the same level.
1
Press SRC or BAND repeatedly to select the desired
mode.
2
Press DISP while pressing SEL.
"LA 0" appears on the display.
3
Turn AUDIO CONTROL to adjust the level.
Note
Adjust the level within 5 seconds, or the selected mode
will be canceled.
Restoring the factory settings
1
Turn off the unit.
2
Press and hold DISP until "LA --" appears on the
display.
Note
You can restore the factory settings only for VOL, BASS,
TRE, BAL, FAD, H-BASS, and BBE, and aligned source
volume levels.

Muting button beep sounds

1
Turn off the unit.
2
Press and hold SEL until "bEEP" appears on the
display.
3
Turn AUDIO CONTROL to select on (level indicators
appear) or off (level indicators disappear).
4
Press SEL.
3 3
ENGLISH ENGLISH
Setting the clock
1
Press and hold DISP until the clock indicator
flashes on the display.
2
Press i (to set hour) or k (to set minute), and
then turn AUDIO CONTROL.
3
Press DISP.
Displaying the clock
1
Press DISP.
To return to the former display, press DISP again.
for the

RADIO OPERATION

Tuning in to a station

(Seek/Manual Tuning)
LO
i/k
BAND
Band indicator Frequency indication
1
Press BAND repeatedly to select the desired band
(FM1, FM2, FM3, AM1, or AM2).
2*
Press i (to move to higher frequencies) or k (to
move to lower frequencies) to tune in to a station.
"ST" appears on the display when an FM station is
broadcasting in stereo, and receiving conditions are
good.
*Seek Tuning and Manual Tuning
• Press and hold i or k until seek Tuning starts.
The unit locates a station automatically (Seek Tuning).
• Press i or k repeatedly to search for a desired
station while increasing or decreasing the frequency
step by step (Manual Tuning).
To stop Seek Tuning, press i or k again.
Stereo indicator Local indicator