Carrier 58UVB Series Installation, Start-Up, And Operating Instructions Manual

rn to the Expertg]
Installation, Start-Up, and
Operating Instruct,ons
NOTE: Read the entire instruction manual before starting the
installation.
TABLE OF CONTENTS
PAGE
SAFETY CONSIDERATIONS ........................ 2
DIMENSIONAL DRAWING .......................... 3
Clearances to Combustibles ........................ 4
CODES AND STANDARDS .......................... 5
ELECTROSTATIC DISCHARGE (ESD) PRECAUTIONS . . 6
INTRODUCTION .................................. 6
APPLICATIONS ................................... 6
General ........................................ 6
Applications ..................................... 6
LOCATION ....................................... 8
General ........................................ 8
Low-Heat Only Installation ........................ 10
Location Relative to Cooling Equipment .............. 10
Hazardous Locations ............................. 10
INSTALLATION .................................. 10
Leveling Legs (If Desired) ......................... 10
Air Ducts ....................................... 11
Filter Arrangement ............................... 11
Bottom Closure Panel ............................. 12
Gas Piping ..................................... 12
Electrical Connections ............................ 14
Removal of Existing Furnaces from Common Vent Systems 17
Combustion-air and Vent Pipe Systems ............... 18
Condensate Drain ................................ 32
START-UP, ADJUSTMENTS. AND SAFETY CHECK . . . 33
General ........................................ 33
AIRFLOW
C>
UPFLOW_
Fig. 1 - Furnace Orientation
A06340
NNI
As an ENERGY STAR(s) Partner,
Carrier Corporation has deter-
mined that this product meets
the ENERGY STAR@ guidelines
for energy efficiency
CERTIFIED
ISO 9001:2000
@
Select Setup Switch Positions ....................... 33
Prime Condensate Trap with Water ................... 34
Purge Gas Lines ................................. 35
Sequence of Operation ............................ 35
Adjustments .................................... 43
Check Safety Controls ............................ 48
CHECKLIST ..................................... 49