YASKAWA SGDH User Manual page 605

11 Appendix
11.3.2 List of Parameters
Parameter
No.
Pn510 Output Signal Selections 3
4th 3rd
digit digit
n.
Pn511
Reserved (Do not change)
Pn512 Output Signal Reversal Settings
4th 3rd
digit digit
n.
Pn600
Regenerative Resistor Capacity
Pn601
Reserved (Do not change)
* 1. Normally set to "0." When using an external regenerative resistor, set the allowable power loss (W)
of the regenerative resistor.
* 2. The upper limit is the maximum output capacity (W) of the SERVOPACK.
Name
2nd
1st
digit
digit
Near Signal Mapping (/NEAR)
(Refer to "8.6.6 Positioning Near Signal.")
0 Disabled (the above signal is not used.)
1 Outputs the signal from CN1-25 or -26 terminals.
Outputs the signal from CN1-27 or -28 terminals.
2
Outputs the signal from CN1-29 or -30 terminals.
3
Reserved (Do not change)
Reserved (Do not change)
Reserved (Do not change)
2nd 1st
digit digit
Output Signal Reversal for CN1-25 or -26 Terminals
0 Output signal is not reversed.
1 Output signal is reversed.
Output Signal Reversal for CN1-27 or -28 Terminals
0
Output signal is not reversed.
1
Output signal is reversed.
Output Signal Reversal for CN1-29 or -30 Terminals
0
Output signal is not reversed.
1
Output signal is reversed.
Reserved (Do not change)
∗1
Setting Range Unit
−
−
−
Depends on SERVO- 10 W
∗2
PACK Capacity
Depends on SERVO-
∗2
PACK Capacity
11-42
Factory Setting
Setting Validation
−
0000 After
restart
−
8888 Immedi-
ately
−
0000 After
restart
0 W Immedi-
ately
−
0 W Immedi-
ately
Reference
Section
−
−
7.3.3
6.5
−