YASKAWA SGDH User Manual page 431

7 Digital Operator/Panel Operator
7.4.1 List of Monitor Modes
(b) Output Signal Monitor Display
The status of output signal allocated to each output terminal is displayed:
When the output is in OFF (open) status, the top segment (LED) is lit.
When the output is in ON (short-circuited) status, the bottom segment is lit.
7 6 5
Refer to 7.3.3 Output Circuit Signal Allocation for the relation between output terminals and signals.
Display LED
Number
Seven segments in the top and bottom rows of an LED turn ON and OFF in different combinations to indi-
cate various output signals.
These segments ON for L level and OFF for H level.
• When ALM signal operates (alarm at H level.)
EXAMPLE
(3) Operation in Monitor Mode
The example below shows how to display the contents of monitor number Un000 when the servomotor rotates at
-1
1500 min .
Display after
Step
Operation
1
2
3
4
Top: OFF (H level)
Bottom: ON (L level)
Number
4 3 2 1
Output Terminal
Name
1
CN1-31, -32
2
CN1-25, -26
3
-
CN1-27, 28
4
CN1-29, -30
5
CN1-37
6
CN1-38
7
CN1-39
7 6 5 4 3 2 1
Digital
Operator
DSPL
SET
(DSPL/SET Key)
DATA
ENTER
(DATA/ENTER K ey)
DATA
ENTER
(DATA/ENTER K ey)
Factory Setting
ALM
/COIN or /V-CMP
/TGON
/S-RDY
AL01
AL02
AL03
The top segment of
number 1 is lit.
Panel
Operator
Press the DSPL/SET or MODE/SET Key to select the
monitor mode.
MODE/SET
(MODE/SET Key)
Press the UP or DOWN Key to select the monitor num-
ber to be displayed. The display shows the example of
the data of Un000.
Press the DATA/ENTER Key once, or DATA/SHIFT
Key for more than one second to display the data of
DATA
Un000.
(DATA/SHIFT Key)
(Press at least 1 s.)
Press the DATA/ENTER Key once, or DATA/SHIFT
Key for more than one second to return to the display
DATA
of monitor number.
(DATA/SHIFT Key)
(Press at least 1 s.)
7-30
Description