Task Management
Toggle bit
This task is used for toggling state of PLC coil or register bit. The bit/coil should be a read-write coil.
This task is executed on coil or bit-addressed register only. User can select coil or bit-addressed register
from tag list.
When this task is executed, the bit/coil is set to 1 if it was 0 previously and vice-versa.
For this task default setting is shown under 'Bit operations'. If user change this selection, task will be
changed.
Click 'OK' to add task in task list.
Copy Tag B to Tag A
This task is used for copying value of one PLC tag to Other PLC tag. The value of tag B will be un-
changed. Tag A will be same as tag B.
E.g..- Tag A = Tag B
This task is executed on register tags and coil or bit-addressed register listed under Tag option. Both tag
type must be of same type; either register type or coil/bit type. If the selected tags are of register type
than this command is executed depending on the tag length (i.e. 1 byte,2 byte, 4 byte ).
For this task default setting is shown under 'Common operations'. If user change this selection, task will
be changed. Click 'OK' to add task in task list.
122