Replacing A Device - Omron DeviceNet Safety NE1A-HDY01 Operation Manual

Replacing a Device

3-3

Replacing a Device

IMPORTANT If a system error occurs due to a hardware error or other fatal error in the
IMPORTANT Before replacing a device using the Replace Device function, be sure that the
1,2,3...
Devices can be easily replaced using the Replace Device function.
device that is being replaced, "H" will be displayed on the leftmost digit of the
7-segment display on an NE1A-series Controller or the MS indicator will light
red on an NE0A-SCPU01 or DST1-series Controller. If that occurs, the
Replace Device function cannot be used, but you can use the download func-
tion to download the device parameters to the new device. Refer to 3-5 Down-
loading Parameters for information on downloading.
Safety Device configuration data of the user system had been validated or
locked. If the Replace Device function is used for a device that is not validated
or locked, the system may not operate properly with the replaced device.
Refer to 3-5-1 Creating Device Parameter Files for information on validating
and locking devices.
1. Connect the Mobile Console to the device to be replaced.
2. Tap the Replace Device Icon in the Main Window.
The following dialog box will be displayed.
3. Tap the Yes Button.
Parameters will be uploaded from the connected device.
• If you tab the No Button, the operation will be stopped and the display
will return to the Main Window.
The following dialog box will be displayed when upload has been complet-
ed.
Section 3-3
49