Sealey PT1170H.V3 Quick Start Manual page 4

NOTE: If hydraulic oil is milky white in colour, water is in the hydraulic system. Change the hydraulic oil immediately.
6.8. Before starting operating the truck, ensure that all markings and decals are on the right place and not damaged. If necessary replace
the decals.
6.9. PURGING AIR FROM THE HYDRAULIC SYSTEM
6.9.1. Air may find its way into the pump during transportation, tilting or usage on uneven ground. It can result in not elevating forks whilst
pumping in the Raise position. The air can be removed in the following way:
Move the control handle to the Lower position, move then the tiller down several times. Thereafter normal operation can be resumed.
6.10. CHECK AND REFILL HYDRAULIC OIL
6.10.1. Ensure forks are in lowered position.
6.10.2. Lay pallet truck on its side with the drain plug of hydraulic cylinder facing up.
6.10.3. Remove the screw plug. Add hydraulic oil until level of oil is at bottom of hole. Replace drain plug, upright the truck.
7. TROUBLESHOOTING
PROBLEM
The forks DO NOT reach maximum
height.
The forks DO NOT lift.
The forks DO NOT lower.
Leaks.
Lifting speed not affected by handle
position.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product
becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and
dispose of the product and fluids according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
CAUSE
Hydraulic oil level too low.
No or low hydraulic oil.
The oil is contaminated.
The lifting/lowering mechanism needs adjustment.
Air in the hydraulic system.
The lifting/lowering mechanism needs adjustment.
Truck stored with ram raised, allowing corrosion.
Forks obstructed.
Seals worn or damaged.
The lifting/lowering mechanism needs adjustment.
Release valve not closing fully owing to oil
contamination.
sales@sealey.co.uk
Original Language Version
SOLUTION
Top up the oil.
Top up tank with hydraulic oil.
Change the oil.
Follow procedure in section 5.
Purge the air as in section 5.
Follow procedure in section 5.
Lubricate piston rod regularly and store in
lowered position.
Remove obstruction.
Replace seals.
Follow procedure in section 5.
Change the oil.
www.sealey.co.uk
PT1170H.V3 Issue 3
REGISTER YOUR
PURCHASE HERE
15/08/23