Table of Contents
Advertisement
Automatic
Ice and Water Dispenser
)o not usethe ice chuteas a handlewhen
removingor replacingtheice storagebin.
Surfaces there may be sharp,
\
\
Do not put fingers up ice chute. Surfaces
there may be sharp.
•
CLEANING
THE ICE DISPENSER
Clean the dispenser and ice container at regular intervals, particularly
before you take a vacation or move, or if the ice dispenser sticks.
1.
Stop ice production by lifting the wire signal arm to the "up" or OFF
position.
2.
Remove ice container by lifting up and out. Empty and carefully clean
the container with mild detergent. Rinse with clear water. Do not use
harsh or abrasive cleaners. Allow ice container to dry completely before
replacing in the freezer.
3.
Remove ice chips and clean the shelf and chute that supports the ice
container.
4.
Replace the ice container. Lower the wire signal arm on the ice
maker to the "down" or ON position and the ice maker will resume
production.
Auger-
IMPORTANT:
When removing or replacing the ice bin. do not
rotate the auger in the ice bin. If the auger is accidentally turned.
you must realign the auger by turning it in 90 ° turns until the ice bin
fits into place with the drive mechanism.
Remove
and empty
the ice storage
bin if:
1.
An extended power failure _one nour or longer) causes ice cubes in
the ice storage bin to melt and freeze together and jam the dispenser
mecnanism.
2.
The ice dispenser is not used frequently Ice cubes will freeze together
in the bin and ,am the dispenser mechanism. Remove the ice storage
bin and snake to loosen the cubes.
NEVER use an ice pick or similar sharp instrument to break up the ice.
This could damage the ice storage bin and dispenser mechanism.
14
Advertisement
Table of Contents
