Troubleshooting - Haier Hdw15U3S1 User Manual

PROBLEM
Dishwasher will
not start
The rinse aid
indicator is lit.
Dishes are not clean. Filters are clogged .
Whitish streaks,
stains or bluish
layers on glasses and
dishes.
30

TROUBLESHOOTING

POSSIBLE CAUSES
No power.
The door is not
properly closed.
has not been
pressed.
Water tap not turned
on.
Blocked strainer in
water inlet hose.
The rinse aid dispenser is
empty .
Filters are not correctly
assembled and installed .
Spray arms are clogged .
Unsuitable wash program
selected .
Incorrect position of the
items in the baskets . Water
could not wash all items .
Spray arms could not turn
freely .
No detergent or insufficient
quantity of detergent in the
detergent dispenser
The wash cycle was
interrupted by a long break
Rinse aid dosage too high .
Quantity of detergent was
too much .
Detergent tablets used with
a short wash program might
not fully dissolve .
WHAT TO DO
Ensure the dishwasher is plugged in and the
power supply is turned on at the wall.
Close the door.
Press .
Ensure water is connected and turned on.
Check the strainer and clean if necessary – it is
located where the water inlet hose screws into
the tap.
Refill the rinse aid dispenser.
Clean the filters.
Make sure that the filters are correctly assembled and
installed .
Remove remaining food remnants with a thin pointed
object .
Make sure that the program is applicable for the type of
load and food remnants .
Make sure that the position of the items in the baskets
is correct and that the water can easily wash all items .
Make sure that the position of the items in the baskets
is correct and does not cause the blockage of the spray
arms .
Make sure that you add the correct quantity detergent
in the dispenser before you start a programme .
Do not open the door or cut power supply during the
wash cycle .
Decrease rinse aid dosage. Refer to 'Rinse aid.'
Make sure that you add the correct quantity of
detergentin the dispenser before you start a
programme .
Select a longer program when using detergent tablets .