Table of Contents
Advertisement
your appliance by means of a straight
connection device (coupling).
e
Маке sure that the natural gas valve is
readily accessible.
e
|[ғуои need to use your appliance later
with a different type of gas, you must
consult the authorised Service for the
related conversion procedure.
Leakage control at the connection point
e
Make sure that all knobs on the
appliance are turned off. Make sure
that the gas supply is on. Prepare
soapy foam and apply it onto the
connection edge of the hose for gas
leakage control.
e
Soapy part will froth if there is a gas
leakage. In this case, inspect the gas
connection once again.
Important
Never use a match or lighter to
check for gas leakage.
Installation
1. Place hob into aperture and align it.
In order to avoid the foreign substances
and liquids penetrating between the
hob and the worktop, please apply the
putty supplied in the package to the
contour of the housing in the worktop
before installation but make sure that
the putty does not overlap.
3. Secure the hob with brackets.
» For worktops 20 mm thick, install the
Bn
as under:
» For worktops 30 mm thick, install the
brackets as under:
» For worktops 40 to 50 mm thick, install
the brackets as under:
5. Connect hob.
Important
Clamping to different holes is not a
good practice in terms of safety
since it can damage the gas and
electrical system.
Final check
. Open gas supply.
2. Check gas installations for secure fitting
and tightness.
Ignite burners and check appearance of
the flame.
Important
The flames should be blue and
burn smoothly. If the flames
appear yellowish, check secure
position of the burner cap or clean
the burner.
Gas conversion
DANGER
à Risk of explosion!
Before starting any work on the
gas installation, please shut off the
gas supply.
Advertisement
Table of Contents
