Advertisement
Quick Links
Advertisement
Related Manuals for System Loco LocoTag T1B
Summary of Contents for System Loco LocoTag T1B
- Page 1 Quick Start Guide LocoTag T1B. Document Version: 0.0.2 04/18/2024...
- Page 2 Introduction. How the System Works The LocoTag T1B Cable Sensor reports through System Loco Hubs such as the HGD4 or HGR4; the devices are paired during device deployment. When activated, the cable sensor tag will report the status of the cable (attached, detached or cut).
- Page 3 Quick Start Guide | LocoTag T1B © Copyright System Loco Ltd 2024 Device Characteristics. Transport Security Seal Point Device ID / Barcode Entry points for Optical cable Additional Transport Security Seal Point www.systemloco.com Document Version: 0.0.2 04/18/2024...
- Page 4 The T1B will monitor the integrity of the security seal and will report its status via a BLE broadcast. The T1B status is reported back to the System Loco server via a reader/hub. To enable this functionality the T1B must be paired with a corresponding hub/reader.
- Page 5 Quick Start Guide | LocoTag T1B © Copyright System Loco Ltd 2024 Step 2 Navigate to the hub/reader Go to the hub/reader device you wish to pair the T1B with and navigate to the settings tab. Step 3 Pair the T1B to Hub/Reader Scroll down to the Paired Devices card and select “Edit”.
- Page 6 Quick Start Guide | LocoTag T1B © Copyright System Loco Ltd 2024 In the Dialogue box, enter the device id of the T1B device that will be paired with the unit. This can be found on the front of the T1B.
- Page 7 Quick Start Guide | LocoTag T1B © Copyright System Loco Ltd 2024 Your device will now show the updated list of paired devices. Note, standard tag reporting requires the “Tag Detection” button to be enabled in the Controls tab of the hub/reader settings. This is not required for the T1B.
- Page 8 Quick Start Guide | LocoTag T1B © Copyright System Loco Ltd 2024 Getting Started - in the Field. Step 1 Activation Remove the battery tab to power on the unit. You may dispose of the battery tab afterward. Once activated, the T1B will transmit data every 10 seconds.
- Page 9 Quick Start Guide | LocoTag T1B © Copyright System Loco Ltd 2024 Step 3 Activating the Security Seal Function Activating the security seal involves connecting the optical cable to the two sockets inside the case. When the optical cable is disconnected, the switch status displays as ‘Open.’...
- Page 10 Quick Start Guide | LocoTag T1B © Copyright System Loco Ltd 2024 Step 4 Securing the T1B to your container / Lorry Trailer Thread the security seal (highlighted in yellow in the diagram) through the top insert of the device, firmly securing the T1B to the vertical bars.
- Page 11 Quick Start Guide | LocoTag T1B © Copyright System Loco Ltd 2024 Batteries. The unit uses a 3V 500mAh primary battery (non-rechargeable) • Do not expose to temperatures >85°C (185°F) • Do not incinerate or disassemble • Recycle after use Certifications.
Need help?
Do you have a question about the LocoTag T1B and is the answer not in the manual?
Questions and answers