D-Link DFL-1100 Quick Installation Manual page 10

The Setup Wizard
Step 4 - Set up built-in DHCP
server
If you want to use the built-in
DHCP Server in the DFL-1100,
choose Enable DHCP Server in
this screen. You then need to
specify a range of IP addresses
to hand out to the DHCP clients.
This range is entered in the
format "Start IP – Stop IP" i.e.
192.168.1.100 – 192.168.1.200.
If you don't want to use the built-
in DHCP Server or configure it
later, choose Disable DHCP
Server and click Next
done.
Click Next
Step 5 - Configure helper
servers
NTP Servers - If enabled,
specify which NTP Servers
that should be used to
syncronize the firewall time
Syslog Servers – If enabled,
specify where the firewall
should log, you can specify
up to two Syslog receivers.
Click Next
when
10
(continued)
192.168.1.100 – 192.168.1.200