Ahead 1 1/8" •
Handlebar diameter
Read the instructions carefully and observe all safety instructions. Only carry out this assembly if you are qualified to do so, otherwise we strongly recommend assembly in a
specialist workshop. Incorrect attachment can negatively affect the handling of the bike and endanger your health and life. The symbols listed below are used in the following, please
note these instructions:
Warning! Important mounting note. Failure to do so may endanger health and life.
Tips for mounting, care or to avoid damage.
You need the following tools:
- Torque wrench (SW3 + SW5)
- Hexagon socket SW2
- Hexagon socket SW3
- Hexagon socket SW5
We expressly recommend installing the
stem exclusively in combination with a
steerer tube [GS] made of metal (not
carbon) and without an external thread.
To adjust, please remove the clamping
screw [S2]. The screws [S4] of the
handlebar covers [LD] should be easily
tightened by hand.
Fig.2
When closed (not swiveled), the stem
must be aligned so that it is transverse to
the direction of travel. First tighten the
clamping screw [S1] hand-tight. Then
open the swivel mechanism, insert the
clamping screw [S2] and tighten the
clamping screws [S1] and [S2] with a
torque of 6Nm.
Rocker Parts GmbH • Christmannshof 10 • 79206 Breisach am Rhein • info@rocker-parts.de
31,8 mm • SLS
Fig.1
The stem must be aligned using spacer
rings [DR] (accessory, not included) so
that it protrudes approx. 1.5 - 2 mm
above the fork shaft. After aligning,
adjust the bearing play by tightening the
ahead cover [D] with the screw [S3] with
approx. 1.5 - 2 Nm. Make sure that the
clamping screw [S1] is loose.
www.rocker-parts.de
Feb. 2024 - Stand V1
mounting instruction
Fig.3
Need help?
Do you have a question about the ROCSTEM BEND MAX and is the answer not in the manual?
Questions and answers