6 quick and easy steps to get you up and running
Unpack your DTR
Step 1 –
Unpack your DTR and check you have all the following accessories:
• Remote control
• Mains lead
• Remote control TV set-up codes (loose sheet)
• 2 x AA batteries to place in your remote control (refer to page 37)
please record the CAN number from the label on your DTR below
please write your viewing card number below
A typical installation
Step 2 –
ANTENNA 2
ANTENNA 2
OUT
iMpoRTANT: Disconnect the power to all your existing equipment.
Now place your DTR where you want to keep it and connect it to your TV as
shown in the diagram, by following these simple instructions:
6
TV Aerial
DO NOT REMOVE
ANTENNA 1
IN
IN
TV SCART
ANTENNA 1
OUT
TV
HDMI
VCR
AUX SCART
LEFT
OPTICAL OUT
RS 232
RIGHT
AC IN