Warranty; Accessories; Technical Data - Kärcher B 110 R Series Manual

Ride-on scrubber
Hide thumbs Also See for B 110 R Series:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 15
Malfunction
The brushes do not rotate
The device does not brake
The waste water drain hose is clogged 1. Open the dosing unit cover at the drain hose.
The "Dose" detergent dosing unit
does not work

Warranty

The warranty conditions issued by our sales company
responsible apply in all countries. We shall remedy pos-
sible malfunctions on your device within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)
A: Packaging unit, B: Quantity required by the device
Description
Roller brush, red (medium, standard)
Roller brush, white (soft)
Roller brush, orange (high / low)
Roller brush, green (hard)
Roller brush, black (very hard)
Microfiber roller
Pad roller shaft
Roller pad, yellow (soft)
Roller pad, red (medium)
Roller pad, green (hard)
A: Packaging unit, B: Quantity required by the device
Description
Disc brush, natural colour (soft)
Disc brush, white
Disc brush, red (medium, standard)
Disc brush, black (hard)
Fine diamond pad, green
Coarse diamond pad, white
Medium diamond pad, yellow
Pad drive board
A: Packaging unit, B: Quantity required by the device
Description
Suction lip set, front PU (red), rear Linatex
Suction lip set, Linatex
PU suction lip set
General
Driving / cleaning speed
Transport speed
Travel speed, backwards
Theoretical surface performance
Theoretical surface performance with side scrubbing deck
Practical surface performance
Fresh water tank capacity
Waste water tank capacity
Coarse dirt container capacity
Volume of detergent tank ("Dose" option)
Detergent dosing
Water dosage
Load per unit area (with driver and full fresh water tank)
Surface pressure
Load per unit area (weight / parking area)
Rectification
1. Reduce the contact pressure.
2. Check if the brushes are blocked by a foreign body and remove the foreign body if necessary.
3. If the motor is overloaded, let the motor cool down.
4. Set the programme switch to "OFF".
5. Wait 10 seconds.
6. Set the program switch to the desired program.
7. Check that the plug of the device is plugged into the cleaning head.
1. Undo the brake lock (see "Operation / Pushing the device").
2. Pull the suction hose off the suction bar and close it by hand.
3. Set the programme switch to "Vacuum".
The blockage is sucked out of the drain hose into the waste water tank.
1. "Dose" version only: Call Customer Service.
Cleaning head with roller brush accessories
R 65
R 75
Part no.
Part no.
4.035-604.0
4.035-605.0
6.907-770.0
6.907-771.0
6.907-726.0
6.907-730.0
6.907-727.0
6.907-731.0
6.907-728.0
6.907-732.0
4.114-054.0
4.114-007.0
4.762-626.0
4.762-627.0
6.369-454.0
6.369-454.0
6.369-456.0
6.369-456.0
6.369-455.0
6.369-455.0
Cleaning head with disc brushes accessories
D 65
D 75
Part no.
Part no.
4.905-012.0
4.905-020.0
4.905-011.0
4.905-019.0
4.905-010.0
4.905-018.0
4.905-013.0
4.905-021.0
6.371-235.0
6.371-236.0
6.371-250.0
6.371-252.0
6.371-251.0
6.371-253.0
4.762-446.0
4.762-447.0
Suction bar accessories
Part no.
4.039-366.0
4.039-356.0
4.039-357.0

Technical data

km/h
km/h
km/h
2
m
/h
2
m
/h
2
m
/h
l
l
l
l
%
l/min
2
N/mm
2
kg/m

Accessories

Description
For maintenance cleaning of heavily soiled floors.
For polishing and maintenance cleaning of sensitive floors.
For scrubbing structural floors (safety tiles, etc.).
For basic cleaning of heavily soiled floors and for coating removal (e.g.
waxes, acrylates).
For maintenance cleaning of smooth floors.
For holding roller pads.
For polishing floors
For cleaning lightly soiled floors.
For cleaning normal to heavily soiled floors.
Description
For polishing floors.
For polishing and maintenance cleaning of sensitive floors.
For cleaning lightly soiled or sensitive floors.
For cleaning heavily soiled floors.
For refreshing lime-containing coverings and epoxy resin-coated floors. 5
For holding pads.
Description
Standard
Tear-proof
Oil-proof
B 110 R 65
B 110 D 65
6
6
6
6
4
4
3900
3900
-
-
2730
2730
110
110
110
110
1,6
-
5
5
0,25...3
0,25...3
0,15...5,7
0,15...5,7
0,62...0,66
0,62...0,66
470...542
470...542
English
A
B
1
2
1
2
1
2
1
2
1
2
1
2
1
2
20
96; 106
20
96; 106
20
96; 106
A
1
1
1
1
5
5
1
A
B
Pair
1 pair
Pair
1 pair
Pair
1 pair
B 110 R 75
B 110 D 75
6
6
6
6
4
4
4500
4500
5100
5100
3150
3150
110
110
110
110
1,8
-
5
5
0,25...3
0,25...3
0,15...5,7
0,15...5,7
0,62...0,66
0,62...0,66
470...542
470...542
B
2
2
2
2
2
2
2
2
25

Advertisement

Table of Contents
loading

This manual is also suitable for:

B 110 r 65B 110 d 65B 110 r 75B 110 d 75

Table of Contents