Table of Contents
Advertisement
Section 4 - Configuration
Jitter Buffer Max:
Enter the maximum value for jitter buffer size. The default is 200 bytes
G.723 Speed:
Select the speed for the G.723 audio codec: 5.3 or 6.3 kbit/s.
Pincode Enable:
Enable or disable the use of pin code before making calls. If Enabled,
enter the pin code below.
P2P Enable:
Enable or disable Peer-to-Peer (P2P) communication.
Line Configuration
The router features two phone ports, each of which can be configured independently to
convert voice traffic into data packets for transmission over an IP network. Configure the
following audio codecs for both VoIP1 and VoIP2 lines. Select the encoding mode which
defines the encoding rate control parameters for each of the following audio codec for both
VoIP1 and VoIP2 lines.
G.722:
Select the mode for the codec (0~7). The default is 1.
G.711 a-law:
Select the mode for the codec(0~7). The default is 2.
G.711 u-law:
Select the mode for the codec (0~7). The default is 3.
G.729:
Select the mode for the codec (0~7). The default is 4.
G.723:
Select the mode for the codec (0~7). The default is 0.
ptime setup
Select the packetization time (ptime): 10, 20, or 30.
Digit Map Enable:
Enable or disable the digital map. If enabled, input the digital map
in the text box below.
D-Link DSL-X3052E User Manual
81
Advertisement
Table of Contents
