Table of Contents
Advertisement
en Cleaning and servicing
Display
1
Factory setting (may vary according to model)
12.2 Changing the basic settings
Requirement: The appliance must be switched off.
Press and hold
for a few seconds.
1.
a The first basic setting is shown on the display.
Use the rotary selector to change the basic setting.
2.
Press
.
3.
a The next basic setting is shown on the display.
4.
Use
to select all of the required basic settings
and change the values.
13 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
13.1 Cleaning products
Only use suitable cleaning products.
WARNING ‒ Risk of electric shock!
An ingress of moisture can cause an electric shock.
Do not use steam- or high-pressure cleaners to
▶
clean the appliance.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
Do not use harsh or abrasive detergents.
▶
Do not use cleaning products with a high alcohol
▶
content.
Do not use hard scouring pads or cleaning
▶
sponges.
Do not use any special cleaners for cleaning the ap-
▶
pliance while it is hot.
Only use glass cleaners, glass scrapers or stainless
▶
steel care products if recommended in the cleaning
instructions for the relevant part.
Wash sponge cloths thoroughly before use.
▶
You can find out which cleaning products are suitable
for each surface or part of the appliance in the indi-
vidual cleaning instructions.
18
Basic setting
Factory setting
Demo mode
Signal volume
Selection
1
= off
= on
1
= off
= on
= low
1
= medium
= high
To save the changes, press and hold
5.
seconds.
Note: The changes to the basic settings will be re-
tained even after a power cut.
12.3 Discarding changes to the basic
settings
Turn the function selector.
▶
a All changes are discarded and not saved.
13.2 Cleaning the appliance
Clean the appliance as specified. This will ensure that
the different parts and surfaces of the appliance are
not damaged by incorrect cleaning or unsuitable clean-
ing products.
WARNING ‒ Risk of burns!
The appliance and its parts that can be touched be-
come hot during use.
Caution should be exercised here in order to avoid
▶
touching heating elements.
Young children under 8 years of age must be kept
▶
away from the appliance.
WARNING ‒ Risk of fire!
Loose food remnants, fat and meat juices may catch
fire.
Before using the appliance, remove the worst of the
▶
food residues and remnants from the cooking com-
partment, heating elements and accessories.
Read the information on cleaning products.
1.
→ Page 18
Observe the information on cleaning the appliance
2.
components or surfaces.
Unless otherwise specified:
3.
Clean the components of the appliance with hot
‒
soapy water and a dish cloth.
Dry with a soft cloth.
‒
Description
Reset the changed settings
to the factory settings.
Switch demo mode on or
off.
Note: Demo mode is only
visible in the first 5 minutes
after connecting the appli-
ance to the mains.
Setting the signal volume.
for a few
Advertisement
Table of Contents
