Table of Contents
Advertisement
Fault
The appliance is not
working.
Appliance paused, but
the drum is rotating.
Home Connect is not
working properly.
No connection to the
home network.
Creasing.
and programme
terminated.
Cause and troubleshooting
There has been a power cut.
Check whether the lighting in your room or other
▶
appliances are working.
There is a software fault.
To restart the appliance, press and hold for ap-
▶
proximately 5 seconds.
Cooling process active.
Not a fault – no action required.
▶
Different causes are possible.
Go to www.home-connect.com.
▶
Wi-Fi is switched off.
Activating Wi-Fi on the appliance.
▶
→ "Activating Wi-Fi on the appliance", Page 41.
Wi-Fi is activated but a connection to your home net-
work cannot be established.
Ensure that the home network is available.
1.
Reconnect the appliance to the home network.
2.
→ "Setting up Home Connect", Page 41
The load is too large.
Observe the maximum load capacity of the
▶
→ "Programmes", Page 28.
The laundry lies in the drum for too long after drying.
Remove the laundry from the drum as soon as the
1.
drying programme has finished.
Spread the items of laundry for cooling.
2.
Unsuitable programme for the type of fabric.
Set the suitable programme for the type of fabric.
▶
→ "Programmes", Page 28
Easy-Care fabrics are dried for too long.
→ "Changing the dryness level", Page 27.
▶
→ "Adjusting the dryness level", Page 27.
▶
Crease-reduction function not activated.
Activate the crease-reduction function.
▶
→ "Buttons", Page 25
Condensation tank filled.
→ "Emptying the condensation container", Page 35.
1.
→ "Inserting the condensation container", Page 36.
2.
→ "Starting the programme", Page 33.
3.
Water drain hose is caught or jammed.
Troubleshooting en
51
Advertisement
Table of Contents
