Table of Contents
Advertisement
Mounting the Switch
Mount the switch on the DIN rail using the DIN rail clip that is attached
to the rear of the unit.
1.
Insert the upper end of DIN rail clip into the back of DIN rail track
from its upper side.
2.
Lightly push the bottom of the DIN rail clip into the track.
3.
Verify that the DIN rail clip is tightly attached on the track.
Connecting to the Network
Connect one end of an Ethernet cable into the Ethernet port of the
switch and the other end to the attached device. All Ethernet ports
support auto MDI/MDIX functionality.
Switch
3 TD+
6 TD-
1 RD+
2 RD-
Straight-Through Cabling Schematic
Always make sure that the cables between the switches and attached
devices (for example - switch, hub, or workstation) are no more than
100 meters (328 feet). The cable must meet EIA/TIA-568 100-ohm
specifications:
•
10BASE-T: Category 3, 4, or 5
•
100BASE-TX: Category 5 or 5e
Router or PC
3 RD+
6 RD-
1 TD+
2 TD-
5
Switch
3 TD+
6 TD-
1 RD+
2 RD-
Crossover Cabling Schematic
Switch
3 TD+
6 TD-
1 RD+
2 RD-
Advertisement
Table of Contents
