Table of Contents
Advertisement
INSTALLATION (continued)
Tower Installation
1
x8
1.
Attach the brackets to the baseplate with the provided M4 flat head screws.
2.
Remove the faceplate and rotate the LCD module, then re-install the faceplate.
3.
Screw the rubber feet with provided M4 round head screws and then put the UPS onto the assembled tower
stand. You can also put the dust covers in the screw holes on the top side of the UPS to prevent dust from falling
into the unit.
BASIC OPERATION
Normal Use
1.
Properly install the UPS.
2.
Connect equipment to the outlets on the rear panel of UPS.
3.
Plug the UPS into a 2 pole, 3 wire grounded receptacle/ wall outlet.
4.
Press the power switch on LCD module once. The display screen will light up and show "UPS On/Off" on the first
line. Use the Up/Down button to select "On" or "Delay On" and then press the Enter button to turn on the UPS.
The display screen will show CyberPower in the first line and the UPS model in the second line. Then the Online or
On Battery Indicator on the LCD module lights up, indicating the UPS is operating from utility or battery.
5.
To turn off the UPS, press the power switch on LCD module once. The display screen will light up and show "UPS
On/Off" on the first line. Use the Up/Down button to select "Off" or "Delay Off" and then press the Enter button
to turn off the UPS. The display screen will show "Goodbye" and all the indicators will be off.
IMPORTANT! For first time usage, plug your UPS into an AC outlet to disable cold start protection. Otherwise, your
UPS will not turn on.
IMPORTANT! Do not use an adapter, line conditioner, or other surge protection devices between the wall outlet and
the UPS. Use of such a device may impede proper operation of the UPS.
Be aware of the following statements:
A.
Your UPS may be used immediately upon receipt. However, charging the battery for at least 12 hours is
recommended to ensure the battery reaches its maximum charge. Charge loss may occur during shipping and
storage. To recharge the battery, simply leave the unit plugged into an AC outlet. The unit will charge in either the
on or off state.
B.
To maintain optimal battery charge, leave the UPS plugged into an AC outlet at all times.
C.
DO NOT plug a laser printer, copier, space heater, vacuum, paper shredder, pumps or other large electrical device
to the UPS. The power demands of these devices will possibly overload and damage your UPS.
D.
Always plug the UPS into a 2 pole, 3 wire grounded receptacle/ wall outlet. Make sure the wall branch outlet is
protected by a fuse or circuit breaker and does not service equipment with large electrical demands, e.g. air
conditioner, refrigerator, copier, etc. Avoid using extension cords.
E.
To prevent the risk of electric shock, follow the steps to ground the UPS:
(a)
Connect a ground wire to the TVSS screw on the rear panel of UPS.
(b)
Connect another side of the ground wire to the ground.
2
x4,
3
x4
6
Advertisement
Table of Contents
