Tape Copying - Pioneer CT-W900R Operating Instructions Manual

TAPE COPYING
From Deck | to Deck Il
1. Insert the recorded tape into deck 1.
2. Insert a blank tape into deck Ii.
3. Set the REVERSE MODE switch @.
4. Select the transport direction
Tape copy is performed in the direction (forward or reverse)
shown by the tape transport indicator. To change the tape
transport direction, press the playback (<J or >} button,
then immediately press the stop ( [_]} button.
5. Press the SYNCHRO COPY button @.
HIGH SPEED:
To copy the whole tape in a short time.
NORMAL SPEED:
To copy the tape while listening to the sound.
¢ When listening to the tape during operation, set the
DOLBY NR switch @.
To Stop Copying
Press the stop ( (_].) button (it will affect both decks).
® This function copies the sound from deck | to deck II.
*® You can either copy the whole tape at normal speed while
listening to the sound, or at double speed to reduce
recording time to one half.
* No-recording level adjustment is required. when copying
tapes.
© The deck il tape is recorded in the same condition of the
deck | tape, regardless of the DOLBY NR switch (4)
position. For example, when copying a Dolby C encoded
tape, the deck Il tape is also recorded with Dolby C.
During double speed copy, all controls become
inoperative except the stop ( [_]) button.
During normal speed copy, the deck Il recording mute
{ © ) and pause ( 00 } buttons also work.
¢ The tape copy mode is canceled when the end of any
one of the tapes is reached, so it is advisable to use tapes
of the same length.
* When copying the same material several times, always
record it from the original tape. Sound quality would
deteriorate if recorded from a copy.
Note on Double Speed Copy
When performing double speed copy, an interference beep might
be recorded if there is a TV nearby. In this case, use normal speed
copy or turn the TV power off.
15
<RRBIOI5>